(1) When the PVC pipe extrusion line is running, if there is a failure in the reducer, it may be caused by damaged bearings or poor lubrication, or gear wear, improper installation and adjustment, or poor meshing. It can be solved by replacing bearings, improving lubrication, replacing gears or adjusting gear meshing.
(2) If the noise that occurs during the operation of the PVC pipe extrusion line is a sharp scratching sound, the possibility of scratching between the shaft head and the gearbox bushing due to the deviation of the barrel position should be considered. The fault problem of PVC pipe extrusion production line can be solved by adjusting the barrel.
(3) If the barrel makes a sound, it may be that the auger is twisted and swept through the hole, or the set temperature is too low, which may cause solid particles to rub against each other. Faults in the PVC pipe extrusion line can be dealt with by straightening the screw and increasing the set temperature.
Weifang Sansen Plastic Machinery Co., Ltd. is a factory specializing in the production of PVC pipe extrusion machines, hose production lines, PVC reinforced hose production machines, etc. For more questions about PVC pipe extrusion production lines, please contact us through the contact information on the website .
