PVC hose production line manufacturers introduction, PVC hose production line in the production process will inevitably have some failures, including the outer surface of plastic pipes rough and unsmooth, to timely adjust the process temperature; The wall thickness of the pipe is uneven, adjust the wall thickness on the mold; There are grooves on the inner surface of the pipe, check whether the inner pipe has entered the water and reduce the internal temperature of the mold; There are grooves on the outer surface of the plastic pipe, and the outlet pressure of the sizing sleeve needs to be adjusted, and the water output is required to be balanced; A jitter ring appears inside the pipe of the PVC hose production line, and the water outlet of the sizing sleeve is adjusted to make the water output uniform; No vacuum, check whether the water inlet of the vacuum pump is blocked; The cutting gauge length is inaccurate, check whether the gauge wheel is pressed, etc.
It is also necessary to remind everyone that in the process of operation, if an abnormal situation is found in the PVC hose production line, it is necessary to stop in time and find special staff to check and deal with it.
